Controller Commands
The following table contains information about the Mid CSP LMC commands of the controller Tango device. A more extensive documentation about command parameters can be found in the Telescope Model - Mid.CSP schemas
Command name |
Description |
Parameters |
Example |
Sequence diagram |
Note |
---|---|---|---|---|---|
On |
The command has an argument list as input that contains the devices FQDN that have to be transition to ON. |
List that contains the devices FQDN. when the list is empty, the commmand is propagated to all the subsystem devices |
|||
Off |
The Off command disables any signal processing capability of a device, |
List that contains the devices FQDN. when the list is empty, the commmand is propagated to all the subsystem devices |
|||
Standby |
Transition the CSP to a low power consumption mode. The CSP LMC controller is responsible to propagate the transition to the subsystems |
List that contains the devices FQDN. when the list is empty, the commmand is propagated to all the subsystem devices |
Mid CBF does not support the command |
||
loadDishCfg |
This command inizializes the Mid.CBF system parameters |
If the command fails or is is not issued, the CBF cannot transition to On state |
|||
Reset |
Recover from a FAULT State. The controller will be move in STANDBY obsState |
No input |
The command is propagated to subarrays |